Why do my Bluetooth PCB fail to pair with Android 7.1 version but work properly with iphone?

It's detecting equipment, Bluetooth emergency alarm. Mobile application for activation button via Bluetooth can not work properly on Android 7.1. If i use iPhone all is ok. Why?

PCB Design
October 13, 2023

If iPhone can connect to the Bluetooth PCB, that means, at least, PCBA is good. The most possible reason is the Bluetooth version.

Bluetooth version is not compatible. Bluetooth is a communication protocol. If the Bluetooth headset supports a version of the Bluetooth protocol that is not compatible with other devices, the connection will fail.

Try to consult Bluetooth chip suppliers and you can get a clear list of compatible phone.
If you are a retailer, it would be better to classify this product by various Bluetooth versions before recommending products with proper Bluetooth to your customer. It is a good way to ensure consumer satisfaction in terms of product and sales service.

#PCB Design #IoT

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

Is solder mask a valid electrical insulator?

There is a copper pour over the entire top of the my PCB, which is part of GND net. It turns out that the surface mounted 1W LEDs I’m going to use have the heat slug connected internally to the LED’s +ve terminal. Can I rely on the solder mask to insulate the +ve voltage (~3V ish) from GND? Long term?

Oliver Smith December 7, 2023

Can I use a hot glue to cover a PCB board to insulate it and prevent it from damage?

I want to DIY PCB board at home, but raw material is limited. Can I hot glue to cover a PCB board? Is it advisable to do that?

Oliver Smith September 20, 2023

How can I separate PCB antenna and SMA connector?

I am designing a prototype PCB for a Lora node. It will have an SMA connector (J2) and a PCB antenna. Switching RF connectors are not available in my area, so as an amateur enthusiast what is a good way to separate the antennas?

Oliver Smith November 17, 2023