What should we look for on PCB samples?

I am a purchase executive. And I have received the PCB samples from supplier. What do usually look for on the samples? What factors should I check?

PCB Assembly
November 15, 2023

Four basic factors you should consider during checking the PCB samples from the supplier.

Quality
Lead Time
Price
Sample Process. There are various processes to carry out PCB assembly. So,

Pay attention to finding an original professional PCB manufacturer.
Pay special attention to approving the process used by the manufacturer to ensure it can meet the requirements of your circuit board design and bulk manufacturing.
After finishing,flying probe testing should be available.

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

What SMT assembly techniques should I employ for a small PCB with only a one SOIC ?

So I’m going to repackage this breakout module for simple SPI with a bus-powered LED light strip. It seems expensive and unnecessary for advanced SMT assembly equipment and since its a small PCB with only a few SMDs. What techniques should I employ for this simple SMT assembly?

Oliver Smith November 23, 2023

Why is IC on Digikey 5 times expensive than board with the same IC on Alibaba?

I am a project procurement a for telecom device. When I compared the unit price of the same IC between Digikey and Alibaba and find Digikey one is much more expensive. Why?

Oliver Smith November 30, 2023

Does anyone have any experience using zero-ohm resistors in an RF signal path to select antennas?

I’ve typically used RF switches for this purpose, but that’s also when it was necessary to allow the antenna selection to be changed “in the field”. But for cases where the antenna selection is a manufacture-time option, I’m considering simple zero-ohm resistors.

Oliver Smith December 6, 2023

What should we look for on PCB samples?

Oliver Smith

Oliver Smith

What Others Are Asking

What SMT assembly techniques should I employ for a small PCB with only a one SOIC ?

Why is IC on Digikey 5 times expensive than board with the same IC on Alibaba?

Does anyone have any experience using zero-ohm resistors in an RF signal path to select antennas?

Read Detailed Advice From Blog Articles

PCBA Manufacturing: A Step-by-Step Guide

Surface Mount Technology (SMT): What Is It? How It Works?

Why Choose PCB Assembly in China?