We often only need the basics of a design to begin the process of PCB design. At MOKO we’re happy to accept any form of input. Some of our customers provide completed CAD generated schematics, but we can work with a hand-drawn sketch if required.
Read More: PCB Design and Layout Services
#PCB Design
Sometimes when I order PCBs from a board house, I omit the bottom silkscreen for budgetary reasons. When I place surface-mount chips on the bottom of the board, I then end up with a footprint that doesn’t indicate the chip orientation. How can I clearly indicate pin 1 with the remaining layers in a way that will be clear but not significantly impact the PCB size or cause issues when soldering?
Last week, I received an email from PCB suppliers, which told that the space between traces and board edge is too small. We were required to make some adjustment on that. So do you have some suggestions on how much space should I leave?
I have two BGA parts on a PCB, with a 32 bit wide bus with a few control lines and a clock line connecting them. Almost all of these traces are only on internal layers. There looks like a signal integrity problem on the bus. The good news is that the board only has parts on one side, and all the vias are through-all. Can anyone suggest good ways to remove the tenting over the vias so they could be probed with an oscilloscope, or at least be able to solder 30 gauge wire to them?
The copper traces on a printed circuit board carry electronic signals and distribute power between components and devices. This complex network of conductive pathways allows all
Have you ever opened up the case of a broken smartphone or smartwatch? If yes, you will be familiar with small circuits packed into such
Antennas play a critical role in any wireless system, which is used to transmit and receive electromagnetic signals that carry data. As electronics continue getting
Electronic Manufacturing
Resources
Contact Us
Copyright ©2024 MOKO Technology | Your Trusted EMS Partner 粤ICP备15085690号