Antennas deal with the world outside the device. This would tend to indicate that they should be located on an outside layer.
While it’s easy to say that circuit board substrate material (woven Fiberglas with epoxy binder) is “transparent” to radio signals, a closer look reveals a dielectric constant of 4 as versus a dielectric constant of 1 for free space. This difference will have an effect on the behavior of the antenna (probably not much at 433 MHz), but it’s still not a good idea to bury the antenna under a layer of laminate.
Don’t locate any other conductors on layers below the antenna – just keep them clear.
Devamını oku: Çok Katmanlı PCB Nedir?
#PCB Tasarımı
Bringing your electronic ideas to life begins with PCB drawing, which is the process of…
Printed Circuit Board design is one of the most significant processes in electronics production. Deciding…
Kullandığımız elektronik cihazlar sürekli değişiyor ve gelişiyor. Daha küçük ve daha işlevsel hale geliyorlar,…
PCB montajı oldukça karmaşık bir süreçtir, doğruluğun her zaman esas olduğu. Even…
Herhangi bir tasarım hatası nedeniyle PCB tasarımının güvenilir olmasını sağlamak önemlidir.,…
Devre kartını tasarlarken, a high level of concentration is given towards PCB signal…