Hayır, I would not rely on a solder mask as an insulator, because it is very thin and can be nicked easily.
The key issue is going to be how to properly heat sink the LED without a good thermal connection to the heat slug. High-power LEDs usually want the heat slug soldered or thermally epoxied to a heatsink. This can be PCB copper, but since you stated that the PCB copper is connected to the GND net you can’t connect to it.
Devamını oku: LED PCB Meclisi
#PCB Düzeneği #PCB Tasarımı
Bringing your electronic ideas to life begins with PCB drawing, which is the process of…
Printed Circuit Board design is one of the most significant processes in electronics production. Deciding…
Kullandığımız elektronik cihazlar sürekli değişiyor ve gelişiyor. Daha küçük ve daha işlevsel hale geliyorlar,…
PCB montajı oldukça karmaşık bir süreçtir, doğruluğun her zaman esas olduğu. Even…
Herhangi bir tasarım hatası nedeniyle PCB tasarımının güvenilir olmasını sağlamak önemlidir.,…
Devre kartını tasarlarken, a high level of concentration is given towards PCB signal…