The question does not specify the expected number of flexing cycles across the device lifetime. For applications where the FPC will be flexed just once at installation, such as connections between the LCD panel and attached backpack controller board, pretty much anything goes. At worst, infantile death of the FPC if it happens, will be detected in a test run.
Assuming multiple flexing cycles:
The location of the via inherently becomes a weak point. Given that flexing already creates stress on the copper layers, this is a conduction breakage waiting to happen. You will notice that if there ever are vias on FPC, they are found on the parts unlikely to bend.
The copper used must also be the thinnest possible, to minimize risk of fracture. This means 1 ounce copper, or thinner even, if the application can stand it.
Devamını oku: Esnek PCB Tasarımı- Nasıl Başarılı Olunur?
#PCB Manufacturing #Flex PCB
BGA reballing emerges as a critical repair technique for modern electronic devices. Şu günlerde, elektronik aletler…
Do you know what PCB stiffeners are? They are widely used in flex and rigid-flex…
In the PCB manufacturing process, PCB warpage is a common problem that manufacturers would encounter.…
In the world of printed circuit board design and manufacturing, precision and accuracy are paramount.…
Soldering is a cornerstone technique in electronics assembly, it's used to connect electrical pieces and…
Şu günlerde, electronic products are both compact and lightweight while performing a variety of functions. Bu…