Evet.
The solder reflow heat mass is significantly greater in assembly line.
| Make by Yourself | Montaj Line |
| You may need some forced air for ramp-down and a thermal couple probe to “profile” a bare board to match the LED recommended ramp rates, peak liquidus dwell and cooling rates to prevent solder stress failures. If you do not have thermal couples , estimate the liquidus point when a tiny blob of solder melts and the duration it is melted. and your overall profile time from the datasheet. Avoid too slow and too fast as the wire bond may shear inside. | Assembly line process engineers do this with a thermally protected data collection module. It slow down the conveyor speeds to absorb the higher heat mass as well as accelerate the temperature rise in the number of zones in their control. Too slow is a reliability issue for LEDs and the overall time to ramp up and down must not be exceeded for this reason. |
Devamını oku: Alüminyum PCB
#PCB Montajı
BGA reballing emerges as a critical repair technique for modern electronic devices. Şu günlerde, elektronik aletler…
Do you know what PCB stiffeners are? They are widely used in flex and rigid-flex…
In the PCB manufacturing process, PCB warpage is a common problem that manufacturers would encounter.…
In the world of printed circuit board design and manufacturing, precision and accuracy are paramount.…
Soldering is a cornerstone technique in electronics assembly, it's used to connect electrical pieces and…
Şu günlerde, electronic products are both compact and lightweight while performing a variety of functions. Bu…