If your PCB has a solder mask, you can fix this with an SMT resistor even when traces are close together. Cut the trace and scrape the solder mask away on both sides of the cut, over a few mm. Solder an 0603 veya 0402 over the cut. If I patch like that, I actually make two cuts a mm apart, and remove the trace by dental pick between both cuts to make sure there’s a decent interruption of the trace.
Alternatif olarak, you can do the same and solder a PTH resistor, whose wires you first bent so that they lay flat on the trace. Won’t probably work as well on narrow traces, like 0.5mm.
Devamını oku: Prototip PCB Montajı İçin Kısa Bir Kılavuz
#PCB Montajı
Bringing your electronic ideas to life begins with PCB drawing, which is the process of…
Printed Circuit Board design is one of the most significant processes in electronics production. Deciding…
Kullandığımız elektronik cihazlar sürekli değişiyor ve gelişiyor. Daha küçük ve daha işlevsel hale geliyorlar,…
PCB montajı oldukça karmaşık bir süreçtir, doğruluğun her zaman esas olduğu. Even…
Herhangi bir tasarım hatası nedeniyle PCB tasarımının güvenilir olmasını sağlamak önemlidir.,…
Devre kartını tasarlarken, a high level of concentration is given towards PCB signal…