For prototype devices (which should last several months and are OK to fail occasionally), it is usually enough to mount the PCB on rubber inserts instead of bare screws). This greatly reduces peak accelerations your PCB sees, while keeping your prototype accessible and requiring minimum design changes.
For commercial products which should last 10 years or more, you want something more robust. I have seen automotive electronics where parts are assembled (or even the whole device is potted) with RTV silicone, which greatly helps with both mechanical sturdiness and heat transfer.
Devamını oku: Otomotiv Elektronik İmalatı
#PCB Montajı
Bringing your electronic ideas to life begins with PCB drawing, which is the process of…
Printed Circuit Board design is one of the most significant processes in electronics production. Deciding…
Kullandığımız elektronik cihazlar sürekli değişiyor ve gelişiyor. Daha küçük ve daha işlevsel hale geliyorlar,…
PCB montajı oldukça karmaşık bir süreçtir, doğruluğun her zaman esas olduğu. Even…
Herhangi bir tasarım hatası nedeniyle PCB tasarımının güvenilir olmasını sağlamak önemlidir.,…
Devre kartını tasarlarken, a high level of concentration is given towards PCB signal…