Or get the chip to tristate the flash pins, contact them with something else and directly write the flash.
Or program the flash chip before soldering it in place.
Next time around have a connector, edge fingers, or pads for a pogo-pin spring contact jig.
#After Sales #PCB Assembly
Dört adet lens düzeneğine mekanik olarak bağlanan görüntüleme sensörlü bir PCB tasarladım. 2-56 vidalar. Düzeneğe hafifçe vurursam veya hafifçe vurursam, vidalar kartı mekanik yapıya karşı sıkı bir şekilde tutuyor olmasına rağmen görüntünün ortaya çıktığını fark ettim. “hamle”. PCB'yi mekanik yapıya sabitlemenin yolları hakkında birkaç öneri almayı umuyorum. Yapıştırıcılar veya benzerleri için herhangi bir öneri? Başka bir şey?
This month we plan to find a proper suppliers to produce PCB for our new products, a healthcare watch. One of our supplier assessment items is about production equipment, which I know few about them. Can you share some common equipment which professional factory may use?
I want to implement a control system I designed for a light electric motorbike. I would like to mount it as professionally as possible on the chassis. It consists of a power system pcb and a SAMC21 development board which I’ll merge later once this all works properly. I have tried screwing it directly on the aluminium chassis but have found that shocks and vibrations from the horn disturbed the system or even destroyed it upon large shocks. Is there a specific way car and motorcycle manufacturers mount their electronics to make their system as robust as possible?
Piyasalar
Kaynaklar
Bizimle iletişime geçin
Copyright ©2025 MOKO Technology | Güvenilir EMS Ortağınız Guangdong ICP No. 15085690
