Basit bir tel antenin ihtiyacı var mı? 50 ohm iletim hattı?

It depends.

If you’re talking about a “long wire” (more typically/accurately, bir random wire antenna) used for receiving only, then the line impedance isn’t at all an issue. As long as it’s properly insulated at the right spots, you can run the wire right up to the receiver input and get excellent results. Using a 50 ohm hattı (which would almost certainly be some type of coax) here would generally be mostly for convenience, because the receiver has an input connector best used with a coaxial cable (Örneğin., a BNC or SO-239).
If we’re talking about an antenna to be used for transmitting, rağmen, the answer becomes more complicated. There are two primary concerns when connecting a transmitter to its antenna:

1. Getting the most power transferred to the antenna and actually radiated.
2. Protecting the transmitter’s output stages from the effects of high SWR.

Available choices of feedlines range from the typical coax cables at 50–75 ohms through “ladder lines” than can have characteristic impedances in the hundreds of ohms.

Devamını oku: Kablo & Kablo Demeti Montajı

#PCB Tasarımı

Oliver Smith

Oliver, PCB tasarımı konusunda yetenekli deneyimli bir elektronik mühendisidir, analog devreler, gömülü sistemler, ve prototipleme. Derin bilgisi şematik yakalamaya kadar uzanıyor, cihaz yazılımı kodlaması, simülasyon, Yerleşim, test yapmak, ve sorun giderme. Oliver, elektrik tasarımı yeteneklerini ve mekanik yeteneğini kullanarak projeleri konsept aşamasından seri üretime geçirme konusunda uzmandır.