What is usually done is that a stiffener is added to the area of the connector. The stiffener is usually FR4 (with no copper) glued/epoxied to the flex on the backside of the connector.
ancak, maybe the application results in minimal bending without stiffeners. What counts as acceptable is rather dependent on the particular parts, the application, and the required reliability and lifetime, so it’s not easy to quantify.
Devamını oku: Sert Esnek PCB Tasarımının En İyi Uygulamaları
#PCB Tasarımı
Bringing your electronic ideas to life begins with PCB drawing, which is the process of…
Printed Circuit Board design is one of the most significant processes in electronics production. Deciding…
Kullandığımız elektronik cihazlar sürekli değişiyor ve gelişiyor. Daha küçük ve daha işlevsel hale geliyorlar,…
PCB montajı oldukça karmaşık bir süreçtir, doğruluğun her zaman esas olduğu. Even…
Herhangi bir tasarım hatası nedeniyle PCB tasarımının güvenilir olmasını sağlamak önemlidir.,…
Devre kartını tasarlarken, a high level of concentration is given towards PCB signal…