Нет, I would not rely on a solder mask as an insulator, because it is very thin and can be nicked easily.
The key issue is going to be how to properly heat sink the LED without a good thermal connection to the heat slug. High-power LEDs usually want the heat slug soldered or thermally epoxied to a heatsink. This can be PCB copper, but since you stated that the PCB copper is connected to the GND net you can’t connect to it.
Прочитайте больше: Светодиодная печатная плата
#Сборка печатной платы #Проектирование печатной платы
BGA reballing emerges as a critical repair technique for modern electronic devices. Настоящее время, электронные устройства…
Do you know what PCB stiffeners are? They are widely used in flex and rigid-flex…
В процессе производства печатных плат, PCB warpage is a common problem that manufacturers would encounter.…
In the world of printed circuit board design and manufacturing, precision and accuracy are paramount.…
Soldering is a cornerstone technique in electronics assembly, it's used to connect electrical pieces and…
Настоящее время, electronic products are both compact and lightweight while performing a variety of functions. Этот…