How can I mark diodes and LEDs on PCB to avoid confusion of Chinese PCB fab?

(On every board we submit a design for assembly, some designers may make PCB fab confused about the orientation of diodes or LEDs. And we had both Eagle's default diodes and KiCad's default diodes sent back from Chinese fab.)

PCB Design
September 19, 2023

I guess, we may add a silkscreen “+” and “-” just outside of the footprint on either end. Just put the diode schematic symbol on the silkscreen. Very Clear.

#LED #PCB Design

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

Why did the SMT pad fall off easily when soldering the PCB boards?

I am a buyer in a telecom company. Recently, an important order of SMT PCBA is delayed due to insophiscated production of a supplier. I am thinking about replace it and just very puzzled about how did their SMT pad fall off easily when soldering the PCB boards. That slows down the whole process.

Oliver Smith September 19, 2023

What should be the size of an NFC antenna given an operating distance?

I am dealing with a project about a PCB with NFC antenna. We are designing PCB now. Do anyone know about the size of an NFC antenna if we want it operate in 10 centimeters?

Oliver Smith November 14, 2023