PCB Design

Is using a via to strengthen surface mount connector on the pad a good or bad practice?

There are some reasons for putting a via in the pad, but strengthening a connector is a new practice for me.

The weakest part of an SMD pad is that the copper could delaminate from the fiberglass, and lift off the PCB itself. Anything you could do to prevent that would help, including making the pad larger or putting a via in the pad itself.

But you have to be careful since putting a via in the pad can cause other issues.

  • The first problem is that it might make the pads not flat enough, so a connector pin won’t make good contact with the pad and thus not get soldered well.
  • The second issue is that the solder could get wicked down the via and leave nothing left for the connector pin. This isn’t a big issue if you are hand soldering, but can be a problem when doing it with automation.

Honestly, if connector strength is an issue, then it is advisable to seriously consider going to a through-hole connector or some type of connector, which gets strength from some other ways. Such as a connector that gets bolted to the chassis itself (and stress on the PCB is minimal).

consulte Mais informação: Montagem SMT

#PCB Design #PCB Assembly

OliverSmith

Oliver é um engenheiro eletrônico experiente, especializado em design de PCB, circuitos analógicos, sistemas embarcados, e prototipagem. Seu profundo conhecimento abrange a captura esquemática, codificação de firmware, simulação, disposição, teste, e solução de problemas. Oliver se destaca em levar projetos desde o conceito até a produção em massa usando seus talentos de design elétrico e aptidão mecânica.

Postagens recentes

Why PCB Warpage Happens and How You Can Prevent It?

No processo de fabricação de PCB, PCB warpage is a common problem that manufacturers would encounter.

22 hours ago

What Is a PCB Netlist? Tudo o que você precisa saber está aqui

In the world of printed circuit board design and manufacturing, precision and accuracy are paramount.

2 weeks ago

What Is Solder Wetting and How to Prevent Poor Wetting?

Soldering is a cornerstone technique in electronics assembly, it's used to connect electrical pieces and

1 month ago

7 Critical Techniques to Improve PCB Thermal Management

Hoje em dia, electronic products are both compact and lightweight while performing a variety of functions. este…

1 month ago

What Is BGA on a PCB? A Complete Guide to Ball Grid Array Technology

As technology continues to advance in the electronics industry, packaging remains one of the key

2 months ago

How to Create a PCB Drawing: A Step-by-Step Guide for Beginners

Bringing your electronic ideas to life begins with PCB drawing, which is the process of

3 months ago