Se o PCB do meu forno de micro-ondas queimar, devo substituir o PCB ou comprar um novo forno de microondas?

Meu micro-ondas está quebrado. Devo mandá-lo para manutenção ou comprar um novo? Que fatores devo considerar neste caso?

You can buy a large Panasonic microwave oven at Home Depot for about $200.

If your microwave oven is blown out, its door latch may break internally and it couldn’t be opened without breaking it. If you are so inquisitive nature that you plan to disassemble it. You will enjoy the cleverness of the device construction.

Contudo, they are not built to be repaired. They are comparatively inexpensive devices that can be used for a pretty long time if not abused.

They are built, inside-out, to not really be serviceable. It is not in the company’s best interest for them to be fixed. It is the company’s best interest for you to buy a new one every 10–20 years, even though fundamentally the feature set doesn’t change.

I have no doubt that you can take it apart. You can probably get the new board back in. But I assume if you can get a hold of the PCB, you’re going to have a terrible time getting the oven back together correctly. And if you don’t get it back together absolutely 100% correto, there is a serious danger that microwave frequency radiation will be leaked when it is operating.

consulte Mais informação: Consumer Electronic Manufacturing

#Consumer Electronic #After Sales

Foto de OliverSmith

OliverSmith

Oliver é um engenheiro eletrônico experiente, especializado em design de PCB, circuitos analógicos, sistemas embarcados, e prototipagem. Seu profundo conhecimento abrange a captura esquemática, codificação de firmware, simulação, disposição, teste, e solução de problemas. Oliver se destaca em levar projetos desde o conceito até a produção em massa usando seus talentos de design elétrico e aptidão mecânica.
Foto de OliverSmith

OliverSmith

Oliver é um engenheiro eletrônico experiente, especializado em design de PCB, circuitos analógicos, sistemas embarcados, e prototipagem. Seu profundo conhecimento abrange a captura esquemática, codificação de firmware, simulação, disposição, teste, e solução de problemas. Oliver se destaca em levar projetos desde o conceito até a produção em massa usando seus talentos de design elétrico e aptidão mecânica.

O que os outros estão perguntando

How much larger should a plated-through hole be than lead diameter to get good solder wetting?

I’m designing a new PCB where I have a whack of connectors that have to line up with the metalwork. There are some problematic connectors. All 4 pins are round. I want to have the holes as small as possible while allowing for good solder adhesion over the full length of the pin. I’m looking for guidance on how much clearance around the component lead I should have in order to get good solder wetting and adhesion.

O que precisamos verificar antes de lançar um design de PCB?

Depois de fazer esforços em um período, Finalmente terminei meu design de PCB. O próximo passo é liberá-los para a fábrica para produção. Para ser honesto, Não quero nenhum erro no meu arquivo que possa interromper o processo de produção. Então, em quais pontos devo prestar atenção ao verificar meu design?

Leia conselhos detalhados de artigos de blog

Role para cima