The soldering process for each side of the PCB is the same.
Geralmente, the surface tension will be enough to hold a BGA in place, given the number of balls compared to the weight of the chip. If it is not the components will be glued, but it is quite rare to need to do it.
By design, one should avoid putting heavy components on each side of the board. On the bottom, there should only be small components.
consulte Mais informação: Devo usar PCB de camada dupla ou PCB de camada única?
#Montagem de PCB #Projeto de PCB
While most people focus on the components and copper traces that make up PCBs, there's…
The right type of PCB material can make or break the performance of your electronics project.…
BGA reballing emerges as a critical repair technique for modern electronic devices. Hoje em dia, dispositivos eletrônicos…
Do you know what PCB stiffeners are? They are widely used in flex and rigid-flex…
No processo de fabricação de PCB, PCB warpage is a common problem that manufacturers would encounter.…
In the world of printed circuit board design and manufacturing, precision and accuracy are paramount.…