PCB Design

Uma antena de fio simples precisa de um 50 linha de transmissão ohm?

It depends.

  • If you’re talking about a “long wire” (more typically/accurately, uma random wire antenna) used for receiving only, then the line impedance isn’t at all an issue. As long as it’s properly insulated at the right spots, you can run the wire right up to the receiver input and get excellent results. Using a 50 linha ohm (which would almost certainly be some type of coax) here would generally be mostly for convenience, because the receiver has an input connector best used with a coaxial cable (por exemplo., a BNC or SO-239).
  • If we’re talking about an antenna to be used for transmitting, no entanto, the answer becomes more complicated. There are two primary concerns when connecting a transmitter to its antenna:
    1. Getting the most power transferred to the antenna and actually radiated.
    2. Protecting the transmitter’s output stages from the effects of high SWR.

Available choices of feedlines range from the typical coax cables at 50–75 ohms through “ladder lines” than can have characteristic impedances in the hundreds of ohms.

consulte Mais informação: Cabo & Montagem do chicote de fios

#PCB Design

OliverSmith

Oliver é um engenheiro eletrônico experiente, especializado em design de PCB, circuitos analógicos, sistemas embarcados, e prototipagem. Seu profundo conhecimento abrange a captura esquemática, codificação de firmware, simulação, disposição, teste, e solução de problemas. Oliver se destaca em levar projetos desde o conceito até a produção em massa usando seus talentos de design elétrico e aptidão mecânica.

Postagens recentes

Why PCB Warpage Happens and How You Can Prevent It?

No processo de fabricação de PCB, PCB warpage is a common problem that manufacturers would encounter.

1 day ago

What Is a PCB Netlist? Tudo o que você precisa saber está aqui

In the world of printed circuit board design and manufacturing, precision and accuracy are paramount.

2 weeks ago

What Is Solder Wetting and How to Prevent Poor Wetting?

Soldering is a cornerstone technique in electronics assembly, it's used to connect electrical pieces and

1 month ago

7 Critical Techniques to Improve PCB Thermal Management

Hoje em dia, electronic products are both compact and lightweight while performing a variety of functions. este…

1 month ago

What Is BGA on a PCB? A Complete Guide to Ball Grid Array Technology

As technology continues to advance in the electronics industry, packaging remains one of the key

2 months ago

How to Create a PCB Drawing: A Step-by-Step Guide for Beginners

Bringing your electronic ideas to life begins with PCB drawing, which is the process of

3 months ago