If you want to meet CE requirements for noise immunity and emissions, a two-layer board would help a lot.
De um modo geral, there is no problem with putting components on both sides of the board, in the same place. If you had a two (or more) placa de camada, you’d probably want to put a ground or power plane between them. Contudo, you can’t do that with a single-layer board. So you should watch out for a fast digital chip interfering with an analog circuit. It would be inadvisable.
Por exemplo, put a microcontroller on one side and a high input impedance buffer on the other. But putting decoupling caps opposite the chip is probably a good plan.
consulte Mais informação: Fabricação de eletrônicos de telecomunicações
#PCB Design
It is important to learn how to clean a circuit board properly if you’re working…
When designing PCBs, selecting the appropriate type of holes for fasteners is crucial. And much…
PCB copper foil is one of the most critical materials in the printed circuit board…
Shenzhen, China - fevereiro 11, 2025 - Tecnologia MOKO, a leading global electronics manufacturing service…
While most people focus on the components and copper traces that make up PCBs, there's…
The right type of PCB material can make or break the performance of your electronics project.…