We use cookies to help you navigate efficiently and perform certain functions. You will find detailed information about all cookies under each consent category below.
The cookies that are categorized as "Necessary" are stored on your browser as they are essential for enabling the basic functionalities of the site. ...
Necessary cookies are required to enable the basic features of this site, such as providing secure log-in or adjusting your consent preferences. These cookies do not store any personally identifiable data.
Functional cookies help perform certain functionalities like sharing the content of the website on social media platforms, collecting feedback, and other third-party features.
Analytical cookies are used to understand how visitors interact with the website. These cookies help provide information on metrics such as the number of visitors, bounce rate, traffic source, etc.
Performance cookies are used to understand and analyze the key performance indexes of the website which helps in delivering a better user experience for the visitors.
Advertisement cookies are used to provide visitors with customized advertisements based on the pages you visited previously and to analyze the effectiveness of the ad campaigns.
The GL5506 has a significantly lower resistance for a given amount of light compared to the GL5516 AND, in dark conditions, the resistance of the GL5516 is significantly higher in resistance (as you would expect).
Czytaj więcej: Elektroniki użytkowej
#Projektowanie PCB
Cała górna część mojej płytki PCB jest zalana miedzią, który jest częścią sieci GND. Okazuje się, że montowane powierzchniowo diody LED o mocy 1 W, których zamierzam użyć, mają ślimak podłączony wewnętrznie do zacisku +ve diody LED. Czy mogę polegać na masce lutowniczej, aby zaizolować napięcie +ve (~3V ok) z GND? Długoterminowy?
When I visit the PCB showroom in factory, I find that there are some pcs with round corners. Czy lepiej mieć zaokrąglone rogi na PCB??
I’m making a 4 layer PCB prototype that uses a bluetooth mcu connected to a 2.4GHz chip antenna. I’m thinking about what to do with the feedline, whether it should be buried on one of the middle layers, or left on the top layer. To get a 50 om linia, should I choose top layer with 13-mil width or buried miccrostrip with 7-mild width?
Zasoby
Skontaktuj się z nami
Copyright ©2025 MOKO Technology | Twój zaufany partner EMS Guangdong ICP nr 15085690
