Nie, I would not rely on a solder mask as an insulator, because it is very thin and can be nicked easily.
The key issue is going to be how to properly heat sink the LED without a good thermal connection to the heat slug. High-power LEDs usually want the heat slug soldered or thermally epoxied to a heatsink. This can be PCB copper, but since you stated that the PCB copper is connected to the GND net you can’t connect to it.
Czytaj więcej: Montaż PCB LED
#PCB Assembly #PCB Design
It is important to learn how to clean a circuit board properly if you’re working…
When designing PCBs, selecting the appropriate type of holes for fasteners is crucial. And much…
PCB copper foil is one of the most critical materials in the printed circuit board…
Shenzhen, Chiny - Luty 11, 2025 - Technologia MOKO, a leading global electronics manufacturing service…
While most people focus on the components and copper traces that make up PCBs, there's…
The right type of PCB material can make or break the performance of your electronics project.…