Wanneer moet ik kiezen 2 laag PCB of 4 laag PCB?

Our brand was focused on common electronic product with single PCB. And this year, we plan to develop a smart range which may require multiple layer PCB. Want to know more about 2 laag PCB of 4 laag PCB.

2-laag PCB is enough to route any circuitry, at least in theory. One layer for vertical tracks, the other for horizontal tracks, connect them with via’s.

If you need route high-speed signals on the PCB, such as RF circuitry, switched-mode power supplies, and long digital buses, 4-lagen are required. They are widely applied in modern datasheets, high-performance semiconductors, switched-mode PSU, heat-rejecting devices.

  • It can ensure the signal integrity, even though the return path for the signal currents is too long and the loop impedance is too high.
  • The radiated EMI will be steady so as to pass CE/FCC.
  • ensure that the device won’t emit too much radiation and would be robust against interference.

Price of a 4 layer PCB is roughly 3x-4x higher than that of a 2-layer one. Echter, most of the time 2 layer is not a viable option.

Lees verder: Moet ik dubbellaagse PCB of enkellaagse PCB gebruiken?

#PCB-ontwerp

Picture of Olivier Smit

Olivier Smit

Oliver is een ervaren elektronica-ingenieur met kennis van PCB-ontwerp, analoge circuits, ingebedde systemen, en prototyping. Zijn diepgaande kennis omvat schematisch vastleggen, firmware-codering, simulatie, indeling, testen, en probleemoplossing. Oliver blinkt uit in het omzetten van projecten van concept naar massaproductie met behulp van zijn elektrische ontwerptalenten en mechanische vaardigheden.
Picture of Olivier Smit

Olivier Smit

Oliver is een ervaren elektronica-ingenieur met kennis van PCB-ontwerp, analoge circuits, ingebedde systemen, en prototyping. Zijn diepgaande kennis omvat schematisch vastleggen, firmware-codering, simulatie, indeling, testen, en probleemoplossing. Oliver blinkt uit in het omzetten van projecten van concept naar massaproductie met behulp van zijn elektrische ontwerptalenten en mechanische vaardigheden.

Wat anderen vragen

Waarom de printplaat koud is, maar LED-lampen zijn nog steeds hot?

I have a THERMAL problem when designing a power LED ALUMINUM PCB. I have 10 5W UV power LEDs.Coldwater flows through water heat sink continuously. The problem is the PCB is cold, maar LED-lampen zijn nog steeds hot? Can anyone give me some advice.

Is paste mask layer, both top and bottom layer, necessary for THT components?

I know the paste mask layer is also called the stencil layer. It’s only used for assembly. I want to know if the paste mask layer (both top and bottom layer) is necessary for through hole components. For SMD components I know the paste mask layer is required to solder the components. Is it necessary for through hole components?

Lees gedetailleerd advies uit blogartikelen

Scroll naar boven