What’s the benefit of outsourcing my PCB layout?

We are a trading company with a heath care brands. We just hesitate about whether design the medical device PCB by ourselves or outsource the design.

November 9, 2023

By outsourcing, you save the time and money required to sustain an extended full in-house design team while getting faster, professional results from an outstanding team that acts as an extension of your engineering department.

Our philosophy is simple: we work hard to make the outsourcing model work for you.

#PCB-ontwerp

https://www.youtu.be/E-F1Z2kP9Cs?si=1-qNY8UKyFjYzkZ_

Olivier Smit

Oliver is een ervaren elektronica-ingenieur met kennis van PCB-ontwerp, analoge circuits, ingebedde systemen, en prototyping. Zijn diepgaande kennis omvat schematisch vastleggen, firmware-codering, simulatie, indeling, testen, en probleemoplossing. Oliver blinkt uit in het omzetten van projecten van concept naar massaproductie met behulp van zijn elektrische ontwerptalenten en mechanische vaardigheden.

Olivier Smit

Wat anderen vragen

What are some of the benefits and downsides of moving from a two layer PCB with components on a single side, to a four layer PCB with components on both sides?

We got a quotation sheet of four layers board but it greatly exceed our budget. So now we are thinking about reduce layers to save cost. Does this solution work?

Olivier Smit oktober 8, 2023

Is using a via to strengthen surface mount connector on the pad a good or bad practice?

I believe I have heard of putting a plugged via right next to a mechanical pad so that the board is stronger there. But I’m not sure what the implications are for putting a via on the pad?

Olivier Smit december 11, 2023

Wat zijn goede software voor het ontwerpen van PCB's??

I usually work for PCB designing and know some useful design software. I want to know what design software you are using. Is there any high recommendation?

Olivier Smit september 19, 2023

What’s the benefit of outsourcing my PCB layout?

Olivier Smit

Olivier Smit

Wat anderen vragen

What are some of the benefits and downsides of moving from a two layer PCB with components on a single side, to a four layer PCB with components on both sides?

Is using a via to strengthen surface mount connector on the pad a good or bad practice?

Wat zijn goede software voor het ontwerpen van PCB's??

Lees gedetailleerd advies uit blogartikelen