What are the possible reasons that a PCB doesn’t work?

I design a PCB file for samples and send it to manufacturer, but the samples can't work now. We are trouble shooting the reason now. What are the common reasons you have met in a wrong PCB?
  • Mistakes in making of schematics: Miss out net names off-page connectors and interconnection is one of the most frequent mistakes. You should check them carefully. Bovendien, if there is a wrong wire connecting and bad wire crossing over each other, your schematics still be malfunctional.
  • Shorting in PCB tracks, sporen, pads, and obstacles: Eigenlijk, there should be no shorting between power and ground check, Vervolgens, you are required to check any stick to proper clearance and track spacing.
  • Power to the Components: Ensure the right polarity connection and ready IC socket connection.
  • Proceed with PCB Assembly section by section
  • No conduction via through hole: Often there is no conduction via through-hole if the plated through home is not proper. In zo'n geval, it is advisable to solder the IC pin on both layers.

Lees verder: Multiple Testing Method

#PCB-assemblage

Picture of Olivier Smit

Olivier Smit

Oliver is een ervaren elektronica-ingenieur met kennis van PCB-ontwerp, analoge circuits, ingebedde systemen, en prototyping. Zijn diepgaande kennis omvat schematisch vastleggen, firmware-codering, simulatie, indeling, testen, en probleemoplossing. Oliver blinkt uit in het omzetten van projecten van concept naar massaproductie met behulp van zijn elektrische ontwerptalenten en mechanische vaardigheden.
Picture of Olivier Smit

Olivier Smit

Oliver is een ervaren elektronica-ingenieur met kennis van PCB-ontwerp, analoge circuits, ingebedde systemen, en prototyping. Zijn diepgaande kennis omvat schematisch vastleggen, firmware-codering, simulatie, indeling, testen, en probleemoplossing. Oliver blinkt uit in het omzetten van projecten van concept naar massaproductie met behulp van zijn elektrische ontwerptalenten en mechanische vaardigheden.

Wat anderen vragen

Do you use SMT or THT for USB mini B connector?

This question is about the advisability of continuing to use a USB mini-B right angle surface mount connector in my pcb designs. On occasion we see one of these connectors peel back or delaminate off the pcb. Immediately the question is asked, why didn’t you use a through hole connector?

How can I separate PCB antenna and SMA connector?

I am designing a prototype PCB for a Lora node. It will have an SMA connector (J2) and a PCB antenna. Switching RF connectors are not available in my area, so as an amateur enthusiast what is a good way to separate the antennas?

Lees gedetailleerd advies uit blogartikelen

Scroll naar boven