What are primary and secondary sides of PCB?

I am designing a 2 layer PCB with components on both side of it. SMT components are one one side of PCB, but TH (door gat) components are on both sides. I need to understanding something mentioned by the supplier called primary and secondary sides.

De primary side is the side that has most of the components, especially the ICs. The most common soldering technique these days is reflow soldering. It is simply easier to get precision temperature profiles on one side of the board only.

De secondary side can also support components, but

  1. it’s harder to control the temperature precisely, en
  2. gravity works against you as the solder paste begins to melt and the components on the underside of the board want to fall off.

Lees verder: Meerlagige printplaat

#PCB-assemblage

Picture of Olivier Smit

Olivier Smit

Oliver is een ervaren elektronica-ingenieur met kennis van PCB-ontwerp, analoge circuits, ingebedde systemen, en prototyping. Zijn diepgaande kennis omvat schematisch vastleggen, firmware-codering, simulatie, indeling, testen, en probleemoplossing. Oliver blinkt uit in het omzetten van projecten van concept naar massaproductie met behulp van zijn elektrische ontwerptalenten en mechanische vaardigheden.
Picture of Olivier Smit

Olivier Smit

Oliver is een ervaren elektronica-ingenieur met kennis van PCB-ontwerp, analoge circuits, ingebedde systemen, en prototyping. Zijn diepgaande kennis omvat schematisch vastleggen, firmware-codering, simulatie, indeling, testen, en probleemoplossing. Oliver blinkt uit in het omzetten van projecten van concept naar massaproductie met behulp van zijn elektrische ontwerptalenten en mechanische vaardigheden.

Wat anderen vragen

Are SMT components bad for high voltage applications?

Many assembly factories are asking for SMT jobs, while I think through hole would be a better option for a high voltage application. Before the high voltage project is started, we need to make a call on SMT or Through hole parts. Is there a study on this?

How can I separate PCB antenna and SMA connector?

I am designing a prototype PCB for a Lora node. It will have an SMA connector (J2) and a PCB antenna. Switching RF connectors are not available in my area, so as an amateur enthusiast what is a good way to separate the antennas?

Lees gedetailleerd advies uit blogartikelen

Scroll naar boven