Misschien bent u gefrustreerd over de reden waarom uw PCB-ontwerp in de fabriek moest worden gewijzigd, but I want to say this is a frequent and common thing in the PCBA OEM market.
Werkelijk, they are checking on Design For Manufacturability (DFM), which can avoid lots of problems during manufacturing. It costs extra time and energy for them to run it through, but is very important to lay a solid base for further procedure.
#PCB-assemblage #PCB Design
Wasmachine werkt niet. Sinds het net een jaar geleden is gekocht, de componenten erin zijn niet oud, ik denk. Dus ik wil het controleren vanaf de printplaat. Any tips on this?
I have a technical question about thermal management with mid-power LED diodes.Do you use thermal vias on the PC board anymore? Either under the LED diode footprint or even around the footprint?
Depends on the application limits and cost targets.
I designed a PCB with an imaging sensor that is mechanically coupled to a lens assembly using four 2-56 schroeven. I’m noticing that even though the screws are holding the board tightly against the mechanical structure if I flick or lightly knock the the assembly the image “moves”. I’m hoping to get a few suggestions for ways to fix the PCB to the mechanical structure. Any suggestions for adhesives or the like? Something else?
markten
Middelen
Neem contact op
Copyright ©2024 MOKO-technologie | Uw vertrouwde EMS-partner Guangdong ICP Nr. 15085690
