How to handle feedline of bluetooth PCB connected to a 2.4GHz chip antenna?

If the space required is too much, a top-layer microstrip is probably better than a buried one. Using a thinner dielectric layer to allow you to reduce the trace width, rather than burying the microstrip.

One scenario where the buried microstrip (or stripline) would be better if the board were used where there are conductive materials (like the lid of the enclosure) close enough to the board to disturb the impedance of a top-layer microstrip.

There are advantages to a wider microstrip line:

It can handle higher power (not likely an issue for Bluetooth).
It have better impedance control due to etching errors being smaller relative to the trace width.

The trade-off is of course the board area used. You need to consider not just the trace width, but also the desire for 3-5 trace widths of clearance around the trace to maintain controlled impedance.

Lees verder: Productie van IoT-elektronica

#PCB Assembly #PCB Design

Olivier Smit

Oliver is een ervaren elektronica-ingenieur met kennis van PCB-ontwerp, analoge circuits, ingebedde systemen, en prototyping. Zijn diepgaande kennis omvat schematisch vastleggen, firmware-codering, simulatie, indeling, testen, en probleemoplossing. Oliver blinkt uit in het omzetten van projecten van concept naar massaproductie met behulp van zijn elektrische ontwerptalenten en mechanische vaardigheden.