Try not to make so long because your outer pinout is sensible. you should be able to do most of this on one layer. With a standard 5 mil trace/space process, you should have no problem fitting a trace between two pads. It should be possible to route that whole thing on one layer.
Lees verder: PCB Design Service
#PCB-ontwerp
Although the adsorption of moisture by FR4 is quite low, what is the best way to minimize it or eliminate it completely?
I want to desolder a tiny surface mount button from the motherboard of a phone. There are a lot of similarly tiny components surrounding it that I do not want to damage with heat from the soldering iron. Can I use aluminium foil in lieu of kapton tape to protect these components?
I have a THERMAL problem when designing a power LED ALUMINUM PCB. I have 10 5W UV power LEDs.Coldwater flows through water heat sink continuously. The problem is the PCB is cold, maar LED-lampen zijn nog steeds hot? Can anyone give me some advice.
markten
Middelen
Neem contact op
Copyright ©2025 MOKO Technology | Uw vertrouwde EMS-partner Guangdong ICP Nr. 15085690
