How do surface mount components withstand heat of reflow while through hole components can not?

Some online tutorials about soldering TH components, like transistors and ICs, are delicate components and can be easily damaged by heat. When it comes to soldering surface mount IC and components, some prefer to use a reflow oven which heats up the them to a temperature above the melting point of solder. So why?

One of the key points to answer your question is thermal stress.

When you apply heat to one pin of a device, there is a sudden and huge temperature difference between that point and the rest of the device. That difference is stress, and the result can be a material breakout.

In an oven, aan de andere kant, all the board is put under a controlled, gradual thermal rise. ALL the points of the device are at almost the same temperature, so there are no thermal stresses (or they are much smaller than) they were when you applied the soldering tool to ONE pin and the rest of the device is at room temperature.

Lees verder: SMT PCB-assemblage

#PCB Assembly #PCB Materials

Picture of Olivier Smit

Olivier Smit

Oliver is een ervaren elektronica-ingenieur met kennis van PCB-ontwerp, analoge circuits, ingebedde systemen, en prototyping. Zijn diepgaande kennis omvat schematisch vastleggen, firmware-codering, simulatie, indeling, testen, en probleemoplossing. Oliver blinkt uit in het omzetten van projecten van concept naar massaproductie met behulp van zijn elektrische ontwerptalenten en mechanische vaardigheden.
Picture of Olivier Smit

Olivier Smit

Oliver is een ervaren elektronica-ingenieur met kennis van PCB-ontwerp, analoge circuits, ingebedde systemen, en prototyping. Zijn diepgaande kennis omvat schematisch vastleggen, firmware-codering, simulatie, indeling, testen, en probleemoplossing. Oliver blinkt uit in het omzetten van projecten van concept naar massaproductie met behulp van zijn elektrische ontwerptalenten en mechanische vaardigheden.

Wat anderen vragen

Do you use SMT or THT for USB mini B connector?

This question is about the advisability of continuing to use a USB mini-B right angle surface mount connector in my pcb designs. On occasion we see one of these connectors peel back or delaminate off the pcb. Immediately the question is asked, why didn’t you use a through hole connector?

Lees gedetailleerd advies uit blogartikelen

Scroll naar boven