We use cookies to help you navigate efficiently and perform certain functions. You will find detailed information about all cookies under each consent category below.
The cookies that are categorized as "Necessary" are stored on your browser as they are essential for enabling the basic functionalities of the site. ...
Necessary cookies are required to enable the basic features of this site, such as providing secure log-in or adjusting your consent preferences. These cookies do not store any personally identifiable data.
Functional cookies help perform certain functionalities like sharing the content of the website on social media platforms, collecting feedback, and other third-party features.
Analytical cookies are used to understand how visitors interact with the website. These cookies help provide information on metrics such as the number of visitors, bounce rate, traffic source, etc.
Performance cookies are used to understand and analyze the key performance indexes of the website which helps in delivering a better user experience for the visitors.
Advertisement cookies are used to provide visitors with customized advertisements based on the pages you visited previously and to analyze the effectiveness of the ad campaigns.
Dots of glue are used where components may fall off. If components are on the bottom side of the board, then all are glued. Boards with bottom side components must be raised on stand-offs to provide clearance from the conveyor.
Lees verder: Dubbelzijdige printplaat: Een gedetailleerde gids voor beginners
#PCB-assemblage
While bored recently, I decided to take apart a few old pieces of electronic equipment and attempt to reverse-engineer them. I’ve been doing pretty well, but I’ve come to an IC that I can identify but doesn’t seem to exist on the manufacturer’s website.
I have a THERMAL problem when designing a power LED ALUMINUM PCB. I have 10 5W UV power LEDs.Coldwater flows through water heat sink continuously. The problem is the PCB is cold, maar LED-lampen zijn nog steeds hot? Can anyone give me some advice.
To my understanding, each process in the operating system contains its own separate Process Control Block. Can someone explain this to me. Does each process have its own PCB or is there just one PCB that contains all the information for all the processes?
markten
Middelen
Neem contact op
Copyright ©2025 MOKO Technology | Uw vertrouwde EMS-partner Guangdong ICP Nr. 15085690
