You probably want to add some mechanical stiffeners to your board. It may be too late for that, echter, since that is usually factored into the PCB design (unless you want to design a new PCB and mounting fixture).
The stiffener would be a rigid piece of metal or other material that runs along the length of your PCB (or sometimes across the center of it) with fasteners to hold the board tightly against it. It can also provide the mounting interface to your optics and/or thermal relief (koellichaam).
#PCB Assembly #PCB Design
Bringing your electronic ideas to life begins with PCB drawing, which is the process of…
Printed Circuit Board design is one of the most significant processes in electronics production. Deciding…
De elektronische apparaten die we gebruiken, veranderen en worden voortdurend geüpgraded. Ze worden kleiner en functioneler,…
PCB-assemblage is een zeer gecompliceerd proces, waarbij nauwkeurigheid altijd van essentieel belang is. Even…
Het is belangrijk om ervoor te zorgen dat een PCB-ontwerp betrouwbaar is, omdat er geen ontwerpfout is gemaakt,…
Tijdens het ontwerpen van de printplaat, a high level of concentration is given towards PCB signal…