We use cookies to help you navigate efficiently and perform certain functions. You will find detailed information about all cookies under each consent category below.
The cookies that are categorized as "Necessary" are stored on your browser as they are essential for enabling the basic functionalities of the site. ...
Necessary cookies are required to enable the basic features of this site, such as providing secure log-in or adjusting your consent preferences. These cookies do not store any personally identifiable data.
Functional cookies help perform certain functionalities like sharing the content of the website on social media platforms, collecting feedback, and other third-party features.
Analytical cookies are used to understand how visitors interact with the website. These cookies help provide information on metrics such as the number of visitors, bounce rate, traffic source, etc.
Performance cookies are used to understand and analyze the key performance indexes of the website which helps in delivering a better user experience for the visitors.
Advertisement cookies are used to provide visitors with customized advertisements based on the pages you visited previously and to analyze the effectiveness of the ad campaigns.
If your order has not been placed, I remind you to tell your supplier the pin diameters of the component that will be on this board.
Echter, your order is finished. But there is still a solution.
Lees verder: Through-hole PCB Vs Surface mount PCB: Welke raden we aan?
#PCB-productie
Om de grootte van een PCB te verkleinen, Ik zal waarschijnlijk kleinere SM-componenten moeten gebruiken. Ik gebruik momenteel vooral 0805 passieven, en ik denk erover om er heen te gaan 0402 or smaller. Apart from power dissipation considerations, any pitfalls I should be aware of when making the transition?
This question is about the advisability of continuing to use a USB mini-B right angle surface mount connector in my pcb designs. On occasion we see one of these connectors peel back or delaminate off the pcb. Immediately the question is asked, why didn’t you use a through hole connector?
My small PCB is mounting a very sensitive fragile sensor on the top surface that has to be wire bonded to the PCB, so I am trying to design a smaller PCB that can be surface mounted to the bigger PCB. How can I get some kind of thin footprint for interconnecting the two PCB boards?
markten
Middelen
Neem contact op
Copyright ©2025 MOKO Technology | Uw vertrouwde EMS-partner Guangdong ICP Nr. 15085690
