If you want to meet CE requirements for noise immunity and emissions, a two-layer board would help a lot.
In het algemeen, there is no problem with putting components on both sides of the board, in the same place. If you had a two (or more) layer board, you’d probably want to put a ground or power plane between them. Echter, you can’t do that with a single-layer board. So you should watch out for a fast digital chip interfering with an analog circuit. It would be inadvisable.
Bijvoorbeeld, put a microcontroller on one side and a high input impedance buffer on the other. But putting decoupling caps opposite the chip is probably a good plan.
Lees verder: Telecom-elektronica productie
#PCB-ontwerp
BGA reballing emerges as a critical repair technique for modern electronic devices. Vandaag de dag, elektronische apparaten…
Do you know what PCB stiffeners are? They are widely used in flex and rigid-flex…
In the PCB manufacturing process, PCB warpage is a common problem that manufacturers would encounter.…
In the world of printed circuit board design and manufacturing, precision and accuracy are paramount.…
Soldering is a cornerstone technique in electronics assembly, it's used to connect electrical pieces and…
Vandaag de dag, electronic products are both compact and lightweight while performing a variety of functions. Dit…