What is usually done is that a stiffener is added to the area of the connector. The stiffener is usually FR4 (with no copper) glued/epoxied to the flex on the backside of the connector.
Echter, maybe the application results in minimal bending without stiffeners. What counts as acceptable is rather dependent on the particular parts, the application, and the required reliability and lifetime, so it’s not easy to quantify.
Lees verder: Best practices van Rigid Flex PCB-ontwerp
#PCB-ontwerp
It is important to learn how to clean a circuit board properly if you’re working…
When designing PCBs, selecting the appropriate type of holes for fasteners is crucial. And much…
PCB copper foil is one of the most critical materials in the printed circuit board…
Shenzhen, China - februari 11, 2025 - MOKO-technologie, a leading global electronics manufacturing service…
While most people focus on the components and copper traces that make up PCBs, there's…
The right type of PCB material can make or break the performance of your electronics project.…