Technical Writer
Oliver is an experienced electronics engineer with over 7 years of experience developing products in IoT, consumentenelektronica, and medical devices. He is highly skilled in analog circuit design, ingebedde systemen, PCB-indeling, firmware-codering, and prototyping electronic products. Oliver’s expertise encompasses the full product development cycle, from concept to mass production. He holds a Master’s degree in Electrical Engineering and leverages his deep technical knowledge to deliver innovative electronic solutions.
I know that using leaded process for lead-free BGA chips is not acceptable, because the solder balls of the BGA will not melt and the joint will be unreliable. But now BGA chip is only available in lead-free balls. is it ok to solder leaded BGA chips with a lead-free (dus, higher temperature) werkwijze?
There are several round pads on the PCB prototypes made by the manufacturer. They are marked Scx and labelled with TP. What are they?
I have a professional question about BGA package. Why is BGA (Ball Grid Array) socket not considered as an actual CPU socket? Anybody knows?
I see recommendations of 2-4 mils voor uitbreiding van het soldeermasker. Maar waarom is het nodig?
I received the PCB design file from supplier. There are some teardrops, which I have seldom seen. Why are there teardrops on the PCB design?
Last week, I visit a PCBA manufacturer for our new project. They not only introduce in-circuit tester but also flying probe tester, which can both ensure the quality level. Zo, Why does the manufacturer use a flying probe tester when they already have an in-circuit tester?
I have a technical question about thermal management with mid-power LED diodes.Do you use thermal vias on the PC board anymore? Either under the LED diode footprint or even around the footprint?
Depends on the application limits and cost targets.
I have a THERMAL problem when designing a power LED ALUMINUM PCB. I have 10 5W UV power LEDs.Coldwater flows through water heat sink continuously. The problem is the PCB is cold, maar LED-lampen zijn nog steeds hot? Can anyone give me some advice.
Zoals we allemaal weten, flex PBC is flexible. I am curious about the reliability of vias in it. Is it easy to break?
markten
Middelen
Neem contact op
Copyright ©2024 MOKO-technologie | Uw vertrouwde EMS-partner Guangdong ICP Nr. 15085690
