Olivier Smit

I want to implement a control system I designed for a light electric motorbike. I would like to mount it as professionally as possible on the chassis. It consists of a power system pcb and a SAMC21 development board which I’ll merge later once this all works properly. I have tried screwing it directly on the aluminium chassis but have found that shocks and vibrations from the horn disturbed the system or even destroyed it upon large shocks. Is there a specific way car and motorcycle manufacturers mount their electronics to make their system as robust as possible?

I am wondering if i ordered some aluminum pcbs that contain D2pak transistors and i want to solder a couple of them for testing is it possible using basic equipment or does it need an reflow soldering oven.

I know the paste mask layer is also called the stencil layer. It’s only used for assembly. I want to know if the paste mask layer (both top and bottom layer) is necessary for through hole components. For SMD components I know the paste mask layer is required to solder the components. Is it necessary for through hole components?

I have three through-hole PCBs that are missing front and back solder mask openings for two of the components. The solder mask (usually green) is covering the front and back solder pads. All other pads for all other parts are exposed. Is there a good way to remove the solder mask so that I can solder the components to the board?

I am designing a 2 layer PCB with components on both side of it. SMT components are one one side of PCB, but TH (door gat) components are on both sides. I need to understanding something mentioned by the supplier called primary and secondary sides.