Technical Writer
Oliver is an experienced electronics engineer with over 7 years of experience developing products in IoT, consumentenelektronica, and medical devices. He is highly skilled in analog circuit design, ingebedde systemen, PCB-indeling, firmware-codering, and prototyping electronic products. Oliver’s expertise encompasses the full product development cycle, from concept to mass production. He holds a Master’s degree in Electrical Engineering and leverages his deep technical knowledge to deliver innovative electronic solutions.
My project have gone through from design, prototype to mass production after lots of discussion and adjustment. Now the manufacturer are making our products in their product lines. And I would like to know is there any differences between the prototypes in my hand now and the final products output by the manufacturer?
Het is de eerste keer dat ik voor mijn onderzoek een prototypebestelling bij een fabrikant plaats. En ik wil weten hoe een gemeenschappelijk prototype eruit ziet.
Our team are developing a portable medical device with a small size, so we need a small PCB. Hoe bepaal ik de sporenbreedte bij het ontwerpen van een printplaat?? Actually we want it as narrow as possible to fit the device, is it OK?
I required a BOM from PCB designer of manufacturer, but he sent me a Gerber. How can I open and read it?
I want to DIY PCB board at home, but raw material is limited. Can I hot glue to cover a PCB board? Is it advisable to do that?
I am a project procurement. Kort geleden, Our project is to develop a television. Of all the materials supply, PCB was the slowest one. And even our engineer took part in the discussion with PCB supplier to push them. Is it really hard to make a RF PCB?
My microwave is broken. Should I send it to maintenance or buy a new one? What factors should I consider in this case?
Wij zijn een bedrijf in huishoudelijke apparaten en zijn nu van plan een magnetron te ontwikkelen. PCB is het belangrijkste onderdeel van het apparaat en we weten dat het geen eendensoep is. Wat zijn de verschillen tussen magnetron-PCB's en gewone PCB's??
I received the price breakdown of PCB quotation from my suppliers. The tooling fee is not so pretty. What is this process and can we skip it to save the cost?
markten
Middelen
Neem contact op
Copyright ©2024 MOKO-technologie | Uw vertrouwde EMS-partner Guangdong ICP Nr. 15085690
