How does a conventional board house deal with the issue of reflow during PCB component assembly with BGA's on both…
Last week we visited a PCBA factory. We were looking at reflow ovens. A lot of them have a metal…
If I want to design a PCB with as much noise immunity as possible, should I leave off test points?…
I have some PCBs that were wave soldered but the vias still remain open, they are not filled nor plugged…
Is there an industry standard for showing how plates in the SMT cap are oriented? How can you tell if…
Printplaten (PCB's) are at the heart of electronics manufacturing. Echter, PCBs can sometimes experience failures due to a…
What I would like to know is if ICs also have a limited shelf life and if so, do some…
The assembly note states: Bake bare PCBs in a clean and well ventilated oven prior to assembly at 125*C for…
I know that using leaded process for lead-free BGA chips is not acceptable, because the solder balls of the BGA…
There are several round pads on the PCB prototypes made by the manufacturer. They are marked Scx and labelled with…