I doubt it makes much difference unless the copper extends beyond the contact that would exist with the dielectric.
If the copper extends, you’ll have better lateral heat spreading and that will conduct through the dielectric so there will be less temperature drop across the dielectric.
Copper conducts heat about 400x better than the dielectric (which may be 50-200um thick) and is typically 35 or 70um thick (1oz/2oz). So extending it at least a few mm should help a little. I’m not sure it’s a huge difference, even at 200um and 1.0 W/m*K the temperature drop at (say) 5W is less than 7°C if I did the sums correctly (10mm x 15mm contact). If a 15 x 20mm pad was isothermal (which it won’t be but say it was a bit bigger than that), then it would reduce the drop to half, saving a few °C. The savings would be proportionally less (or worse) if the dielectric was thinner, so it might not be much.
続きを読む: 重い銅のPCB
#PCB Design #PCB Materials
プリント基板の製造工程において, PCB warpage is a common problem that manufacturers would encounter.…
In the world of printed circuit board design and manufacturing, precision and accuracy are paramount.…
Soldering is a cornerstone technique in electronics assembly, it's used to connect electrical pieces and…
最近は, electronic products are both compact and lightweight while performing a variety of functions. この…
As technology continues to advance in the electronics industry, packaging remains one of the key…
Bringing your electronic ideas to life begins with PCB drawing, which is the process of…