There are some reasons for putting a via in the pad, but strengthening a connector is a new practice for me.
The weakest part of an SMD pad is that the copper could delaminate from the fiberglass, and lift off the PCB itself. Anything you could do to prevent that would help, including making the pad larger or putting a via in the pad itself.
But you have to be careful since putting a via in the pad can cause other issues.
Honestly, if connector strength is an issue, then it is advisable to seriously consider going to a through-hole connector or some type of connector, which gets strength from some other ways. Such as a connector that gets bolted to the chassis itself (and stress on the PCB is minimal).
続きを読む: SMTアセンブリ
#PCB 設計 #PCB アセンブリ
プリント基板の製造工程において, PCB warpage is a common problem that manufacturers would encounter.…
In the world of printed circuit board design and manufacturing, precision and accuracy are paramount.…
Soldering is a cornerstone technique in electronics assembly, it's used to connect electrical pieces and…
最近は, electronic products are both compact and lightweight while performing a variety of functions. この…
As technology continues to advance in the electronics industry, packaging remains one of the key…
Bringing your electronic ideas to life begins with PCB drawing, which is the process of…