はい.
The solder reflow heat mass is significantly greater in assembly line.
| Make by Yourself | アセンブリ Line |
| You may need some forced air for ramp-down and a thermal couple probe to “profile” a bare board to match the LED recommended ramp rates, peak liquidus dwell and cooling rates to prevent solder stress failures. If you do not have thermal couples , estimate the liquidus point when a tiny blob of solder melts and the duration it is melted. and your overall profile time from the datasheet. Avoid too slow and too fast as the wire bond may shear inside. | Assembly line process engineers do this with a thermally protected data collection module. It slow down the conveyor speeds to absorb the higher heat mass as well as accelerate the temperature rise in the number of zones in their control. Too slow is a reliability issue for LEDs and the overall time to ramp up and down must not be exceeded for this reason. |
続きを読む: アルミPCB
#PCBアセンブリ
It is important to learn how to clean a circuit board properly if you’re working…
When designing PCBs, selecting the appropriate type of holes for fasteners is crucial. And much…
PCB copper foil is one of the most critical materials in the printed circuit board…
深セン, 中国 - 2月 11, 2025 - MOKOテクノロジー, a leading global electronics manufacturing service…
While most people focus on the components and copper traces that make up PCBs, there's…
The right type of PCB material can make or break the performance of your electronics project.…