If the space required is too much, a top-layer microstrip is probably better than a buried one. Using a thinner dielectric layer to allow you to reduce the trace width, rather than burying the microstrip.
One scenario where the buried microstrip (or stripline) would be better if the board were used where there are conductive materials (like the lid of the enclosure) close enough to the board to disturb the impedance of a top-layer microstrip.
There are advantages to a wider microstrip line:
The trade-off is of course the board area used. You need to consider not just the trace width, but also the desire for 3-5 trace widths of clearance around the trace to maintain controlled impedance.
続きを読む: IoTエレクトロニクス製造
#PCB アセンブリ #PCB 設計
BGA reballing emerges as a critical repair technique for modern electronic devices. 最近は, 電子デバイス…
Do you know what PCB stiffeners are? They are widely used in flex and rigid-flex…
プリント基板の製造工程において, PCB warpage is a common problem that manufacturers would encounter.…
In the world of printed circuit board design and manufacturing, precision and accuracy are paramount.…
Soldering is a cornerstone technique in electronics assembly, it's used to connect electrical pieces and…
最近は, electronic products are both compact and lightweight while performing a variety of functions. この…