If the leads are flat or square rather than round, you can go a bit tighter on the diagonal dimension, assuming a round hole. For really flat leads, it’s better to specify a slot.
If you’re using some kind of special part, such as a staked connector or press-fit part, pay attention to the tolerances.
続きを読む: スルーホールPCBアセンブリ
#PCB アセンブリ #PCB 設計
Bringing your electronic ideas to life begins with PCB drawing, which is the process of…
Printed Circuit Board design is one of the most significant processes in electronics production. Deciding…
基板設計時, a high level of concentration is given towards PCB signal…