Use SMT.
I have experienced such a problem with the SMT Mini USB B connector in the past. 通常, the solution is to design the enclosure so that it will not allow any movement of the connector against the PCB.
As for the reason why to use SMT, SMT components are cheaper to assemble in large quantities. 結果として, through-hole components usually require special approval in most designs targeting mass production.
続きを読む: スルーホールPCBアセンブリ
#PCB 設計 #PCB アセンブリ
Bringing your electronic ideas to life begins with PCB drawing, which is the process of…
Printed Circuit Board design is one of the most significant processes in electronics production. Deciding…
基板設計時, a high level of concentration is given towards PCB signal…