If you want to meet CE requirements for noise immunity and emissions, a two-layer board would help a lot.
一般的に言えば, there is no problem with putting components on both sides of the board, in the same place. If you had a two (or more) レイヤーボード, you’d probably want to put a ground or power plane between them. しかしながら, you can’t do that with a single-layer board. So you should watch out for a fast digital chip interfering with an analog circuit. It would be inadvisable.
例えば, put a microcontroller on one side and a high input impedance buffer on the other. But putting decoupling caps opposite the chip is probably a good plan.
続きを読む: テレコムエレクトロニクス製造
#PCB設計
Bringing your electronic ideas to life begins with PCB drawing, which is the process of…
Printed Circuit Board design is one of the most significant processes in electronics production. Deciding…
基板設計時, a high level of concentration is given towards PCB signal…