Se il PCB del mio forno a microonde è bruciato, dovrei sostituire il PCB o acquistare un nuovo forno a microonde?

Il mio microonde è rotto. Dovrei mandarlo in manutenzione o comprarne uno nuovo? Quali fattori dovrei considerare in questo caso??

You can buy a large Panasonic microwave oven at Home Depot for about $200.

If your microwave oven is blown out, its door latch may break internally and it couldn’t be opened without breaking it. If you are so inquisitive nature that you plan to disassemble it. You will enjoy the cleverness of the device construction.

però, they are not built to be repaired. They are comparatively inexpensive devices that can be used for a pretty long time if not abused.

They are built, inside-out, to not really be serviceable. It is not in the company’s best interest for them to be fixed. It is the company’s best interest for you to buy a new one every 10–20 years, even though fundamentally the feature set doesn’t change.

I have no doubt that you can take it apart. You can probably get the new board back in. But I assume if you can get a hold of the PCB, you’re going to have a terrible time getting the oven back together correctly. And if you don’t get it back together absolutely 100% corretta, there is a serious danger that microwave frequency radiation will be leaked when it is operating.

Leggi di più: Consumer Electronic Manufacturing

#Consumer Electronic #After Sales

Immagine di Oliver Smith

Oliver Smith

Oliver è un ingegnere elettronico esperto specializzato nella progettazione di PCB, circuiti analogici, sistemi integrati, e prototipazione. La sua profonda conoscenza spazia dall'acquisizione di schemi, codifica del firmware, simulazione, disposizione, analisi, e risoluzione dei problemi. Oliver eccelle nel portare i progetti dall'ideazione alla produzione di massa utilizzando il suo talento nella progettazione elettrica e la sua attitudine meccanica.
Immagine di Oliver Smith

Oliver Smith

Oliver è un ingegnere elettronico esperto specializzato nella progettazione di PCB, circuiti analogici, sistemi integrati, e prototipazione. La sua profonda conoscenza spazia dall'acquisizione di schemi, codifica del firmware, simulazione, disposizione, analisi, e risoluzione dei problemi. Oliver eccelle nel portare i progetti dall'ideazione alla produzione di massa utilizzando il suo talento nella progettazione elettrica e la sua attitudine meccanica.

Cosa chiedono gli altri

What is the difference between a prototype PCB and a production PCB?

My project have gone through from design, prototype to mass production after lots of discussion and adjustment. Now the manufacturer are making our products in their product lines. And I would like to know is there any differences between the prototypes in my hand now and the final products output by the manufacturer?

Come posso saldare un componente SMD con un pad sul fondo?

I am getting a PCB manufactured for a project that I am working on. One of the parts, the A4950 motor driver, has a “pad” on the bottom, which is meant to be soldered to GND of the PCB for thermal dissipation. I was thinking about the prototyping, and I am unsure how I would go about (using a soldering iron), soldering the pad on the bottom.

Leggi consigli dettagliati dagli articoli del blog

Scorri verso l'alto