in primo luogo, check whether your PCB is high voltage. Parlando in generale, high voltage is defined as starting at 1000V.
Detto ciò, there is absolutely nothing wrong in general with using surface-mount parts in a device running at these voltages, so long as the parts you are using are rated for voltages you are using them at. Keep in mind as well that you do not need to make a single decision between SMT and through-hole parts. You can mix and match both within a single design.
#PCB Design #PCB Assembly
BGA reballing emerges as a critical repair technique for modern electronic devices. Al giorno d'oggi, Introduzione di un nuovo prodotto…
Do you know what PCB stiffeners are? They are widely used in flex and rigid-flex…
Nel processo di produzione dei PCB, PCB warpage is a common problem that manufacturers would encounter.…
In the world of printed circuit board design and manufacturing, precision and accuracy are paramount.…
Soldering is a cornerstone technique in electronics assembly, it's used to connect electrical pieces and…
Al giorno d'oggi, electronic products are both compact and lightweight while performing a variety of functions. Questo…