No, I would not rely on a solder mask as an insulator, because it is very thin and can be nicked easily.
The key issue is going to be how to properly heat sink the LED without a good thermal connection to the heat slug. High-power LEDs usually want the heat slug soldered or thermally epoxied to a heatsink. This can be PCB copper, but since you stated that the PCB copper is connected to the GND net you can’t connect to it.
Read More: LED PCB Assembly
#PCB Assembly #PCB Design
Impedance matching has become a cornerstone of the signal integrity in the realm of high speed PCB…
It is important to learn how to clean a circuit board properly if you’re working…
When designing PCBs, selecting the appropriate type of holes for fasteners is crucial. And much…
PCB copper foil is one of the most critical materials in the printed circuit board…
Shenzhen, China - February 11, 2025 - MOKO Technology, a leading global electronics manufacturing service…
While most people focus on the components and copper traces that make up PCBs, there's…