I would like some boards on a panel to have different parts assembled while others are not assembled. How can I place this order?

We would like to assembly the smart chip by ourselves because and then ensure the wifi pairing. Any cautions when we place the order to factory to assembly extra part?

PCB Assembly
October 8, 2023

Remark your special requirement in the order.
Detail and explain your requirements in the email. It would be better to show pictures to make it clear.
If necessary, hold a meeting to promote communication, including making prototypes, finished products of this order and delivery.

Oliver Smith

Oliver is an experienced electronics engineer skilled in PCB design, analog circuits, embedded systems, and prototyping. His deep knowledge spans schematic capture, firmware coding, simulation, layout, testing, and troubleshooting. Oliver excels at taking projects from concept to mass production using his electrical design talents and mechanical aptitude.

Oliver Smith

What Others Are Asking

How can I separate PCB antenna and SMA connector?

I am designing a prototype PCB for a Lora node. It will have an SMA connector (J2) and a PCB antenna. Switching RF connectors are not available in my area, so as an amateur enthusiast what is a good way to separate the antennas?

Oliver Smith November 17, 2023

What do we need to check before releasing a PCB design?

After making efforts in a period, I finally finish my PCB design. Next step is releasing them to factory for production. To be honest, I don’t want any mistake on my file which may interrupt further prodution process. So what points should I pay attention when I double-check my design?

Oliver Smith September 13, 2023

I forgot a resistor on my PCB prototype – how do I add one in?

I need to add a resistor into a data line on my project. The data line is a trace and carries low speed data. A through-hole resistor will be fine. The pins for both ends of the trace are exposed, but how do I add the resistor and remove the trace?

Oliver Smith October 26, 2023