Try not to make so long because your outer pinout is sensible. you should be able to do most of this on one layer. With a standard 5 mil trace/space process, you should have no problem fitting a trace between two pads. It should be possible to route that whole thing on one layer.
Read More: PCB Design Service
#PCB Design
Is it possible to connect a standard mezzanine connector to a flex PCB?
I.e. could I use a mezzanine connector meant for connecting two rigid PCBs in a situation where one is flex and one is rigid?
Technology got better: sensitivity increased, antenna design got better so patch antennas (integrated with PCB or integrated with the case) became not just practical but
Recently, I have learnt about kernel and find a question that who controls the process control block(PCB)?The kernel or the process itself? Does it differ in different platform (windows/Linux)? So far, I know PCB is controlled in hardware, but I can’t get to the right answer.
PCB Schematic: What Is It? Why Is It Important? A printed circuit board design starts with a PCB schematic diagram. This PCB schematic layout visually depicts the
A common question when designing complex printed circuit boards for advanced electronics is whether to use stacked or staggered vias to route connections between layers.
As 5G networks roll out globally, they promise to transform connectivity and push the boundaries of what’s possible with mobile technology. But to fully harness
Electronic Manufacturing
Resources
Contact Us
Copyright ©2024 MOKO Technology | Your Trusted EMS Partner 粤ICP备15085690号